ASROCK P4I65PE, Installation Manual

Page: 10 / 80

1 0 1 0
1 0 1 0 1 0
ASRock P4i65PE Motherboard
EnglishEnglishEnglishEnglishEnglish
2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots)
2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots)
There are 5 PCI slots and 1 AGP slot on P4i65PE motherboard.
PCI slots: The PCI slots are used to install expansion cards that have the 32-bit
PCI interface.
AGP slot: The AGP slot is used to install a graphics card. The ASRock AGP slot
has a special locking mechanism which can securely fasten the graph-
ics card inserted.
Do NOT use a 3.3V AGP card on the AGP slot of P4i65PE motherboard!
It may cause permanent damage!
Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card
Step 1. Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
Step 2. Remove the system unit cover (if your motherboard is already installed in a
chassis).
Step 3. Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
Step 4. Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5. Fasten the card to the chassis with screws.
Step 6. Replace the system cover.