ASROCK M3A760GMH, Manual

Page: 18 / 45

1 8 1 8
1 8 1 8 1 8
ASRock M3A760GMH Motherboard
EnglishEnglishEnglishEnglishEnglish
Open Short
Clear CMOS Default
2.6 2.6
2.6 2.6
2.6 Jumpers Setup Jumpers Setup
Jumpers Setup Jumpers Setup
Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is “Short”. If no jumper cap
is placed on pins, the jumper is “Open”. The
illustration shows a 3-pin jumper whose pin1
and pin2 are “Short” when jumper cap is
placed on these 2 pins.
Jumper Setting
PS2_USB_PW1 Short pin2, pin3 to enable
(see p.2, No. 1)
+5VSB (standby) for PS/2 or
USB23 wake up events.
Note: To 5VSB, it requires 2 Amp and higher standby current provided by
power supply.
USB_PW2 Short pin2, pin3 to enable
(see p.2, No. 35)
+5VSB (standby) for
USB01/45 wake up events.
Note: To 5VSB, it requires 2 Amp and higher standby current provided by
power supply.
USB_PW1 Short pin2, pin3 to enable
(see p.2, No. 9)
+5VSB (standby) for
USB6_7/8_9/10_11 wake up
events.
Note: To 5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 24)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3
on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right
after you update the BIOS. If you need to clear the CMOS when you just finish
updating the BIOS, you must boot up the system first, and then shut it down
before you do the clear-CMOS action.