14
English
Serial ATA2 Connectors
(SATA2_1:
see p.5, No. 10)
(SATA2_2:
see p.5, No. 12)
These two SATA2
connectors support SATA
data cables for internal
storage devices with up to
3.0 Gb/s data transfer rate.
USB 2.0 Header
(9-pin USB4_5)
(see p.5, No. 7)
Besides three USB 2.0
ports on the I/O panel,
there is one header on this
motherboard. This USB
2.0 header can support
two ports.
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.5, No. 16)
This header is for
connecting audio devices
to the front audio panel.
3W Audio AMP Output
Wafer Header
(4-pin SPEAKER2)
(see p.5, No. 17)
Please connect the chassis
speaker to this header.
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to
connect them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel
and adjust “Recording Volume”.
SATA2_1
SATA2_2
J_SENSE
OUT2_L
1
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
Front_R-
Front_L-
1
DUMMY
GND
GND
P+
P-
USB_PWR
P+
P-
USB_PWR
1
Summary of Contents for IMB-153
Page 1: ...IMB 153 User Manual ...
Page 14: ...10 English 1 2 3 ...
