ASROCK A770CROSSFIRE, User Manual

Page: 22 / 193

2 2 2 2
2 2 2 2 2 2
ASRock A770CrossFire Motherboard
EnglishEnglishEnglishEnglishEnglish
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 9)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors These six Serial ATAII (SATAII)
(SATAII_1:
connectors support SATAII
see p.2, No. 18)
or SATA hard disk for internal
(SATAII_2:
storage devices. The current
see p.2, No. 19)
SATAII interface allows up to
(SATAII_3:
3.0 Gb/s data transfer rate.
see p.2, No. 17)
(SATAII_4:
see p.2, No. 15)
(SATAII_5:
see p.2, No. 16)
(SATAII_6:
see p.2, No. 14)
connect the black end
to the IDE devices
connect the blue end
to the motherboard
SATAII_6 connector can be used for internal storage device or be
connected to eSATAII connector to support eSATAII device. Please read
“eSATAII Interface Introduction” on page 27 for details about eSATAII
and eSATAII installation procedures.
80-conductor ATA 66/100/133 cable
SATAII_1 SATAII_3 SATAII_5
SATAII_2 SATAII_4 SATAII_6
the red-striped side to Pin1