Back
ECOCOMFORT 2.0 SMART
ECOCOMFORT 2.0 SMART
7
1.1.2. Warnings
1.1.3. Regulations
Carefully read the installation instructions, the safety warnings, and the use and maintenance instructions in this manual, which must be
stored
with care for any future consultation.
– The unit should only be installed by qualified technicians, in compliance with current standards and interposing an all-pole switch
with contact opening distance equal to or greater than 3 mm.
– The unit is intended to ventilate residential premises with heat recovery; different uses are not permitted and shall exempt the
manufacturer from any responsibilities for the consequences resulting from improper use, as well as incorrect installation.
– After removing the packaging, ensure the product is intact; if in doubt do not use it.
– The use of any electrical appliance implies the observance of some fundamental rules. In particular:
• Do NOT touch the appliance with wet hands, or wet or bare feet.
• Do NOT expose the unit to atmospheric agents (rain, sun, etc.).
• Before performing any maintenance or cleaning, disconnect the unit from the mains power supply, opening the all-pole switch
installed on the line.
• Do NOT power the appliance with the lid open.
– The unit complies with 2014/30/EU and 2014/35/EU European Directives.
– Do not obstruct the intake grille.
– In compliance with current accident prevention legislation, ensure that the unit moving parts cannot be accessed after installation.
If an appliance operating on gas (or other fuels) is installed in the room to be ventilated, make sure there is an adequate exchange of
air to ensure the perfect combustion thereof and proper operation of the fan unit.
– Do not install an extractor fan in the same duct where the fumes of a gas appliance are conveyed.
– The unit can be installed only on a wall
Waste disposal
The crossed-out wheelie bin symbol on the equipment indicates that at the end of its work life, the product must be
disposed of separately from other waste.
As such, the user must bring the equipment at the end of its life to appropriate electronic and electrotechnical waste
collection centres or bring it back to the dealer when purchasing new equipment that is equivalent on a one-to-one
ratio. Appropriate separate collection of the equipment for it to be subsequently recycled, treated and disposed of in an
environmentally compatible way contributes to preventing possible negative effects on the environment and on health,
and favours recycling the materials that make up the equipment. Illegally disposing of the product will subject the user to
administrative sanctions pursuant to Leg.Dec. 22/1997” (article 50 and subsequent of Leg.Dec.no. 22/1997).
