aspenhome
R
ASSEMBLY INSTRUCTIONS
MADE IN VIETNAM
ah
Page 5/7
STEP 3: Screw the bolts(E) into HB & FB. Make sure the slat bearer is in the position (a).
Align the bolts with the holes in the end of side rails and attach the side rails to HB & FB using flat
washer(G), lock washers(F) and nuts(H).Then use a hex wrench(I) to tighten all the nuts.
E
F
G
H
I
Headboard
For option 2:
b
a
STEP 2: The slat bearers have been attached in position (b)
approximately 2" from the top of the
side
rails for the Option 1 configuration. The slat bearers must be moved into position (a) based on this
bed configuration. Remove the bolts and screws from the slat bearers and side rails as shown
below. Then re-attach the slat bearers to the side rails in position (a) with bolts, lock washers, flat
washers, and screws.
Caution: Do not over tighten bolts as this may loosen the threaded
inserts in the side rails.
Slat Bearer
Side Rail
Make sure the slat bearer
is in the position (a).
Position b
Position a
STEP 4: Remove the support legs (top)
as shown in the picture
to the right
. Attach the support legs with leveler to the slats.
Adjust the levelers on bottom of support legs when necessary.
Support Leg
Leveler
This End Up
Slat
Remove
Support Leg(top)
ITEM NO: I597-415 King Panel HB
I597-406 King Rails w/ Decking
I597-410 Cal King Rails w/ Decking
I597-407 King Low Profile FB
04-13-2022
