Desk Back
Screw
F
E
Wire
C
B
A
D
F
Desk Back
AC outlet
STEP 1: Put the desk top face down on a soft surface.
STEP 2: Place Lift Mechanism IUAB-301-1 on desk top and adjust to align with threaded inserts. Follow Step 3 from
the IUAB-301-1 assembly instructions for adjusting width of Lift Mechanism.
STEP 3: Secure Lift Mechanism IUAB-301-1 to desk top by using 8 bolts(A), 4 wood screws (F), 8 lock washers(B)
and 8 flat washers(C). Then use an allen wrench to tighten all the bolts.
Page 2/2
aspenhome
R
ASSEMBLY INSTRUCTIONS
MADE IN VIETNAM
Threaded insert
Note: Refer to Lift Mechanism assembly instructions for Handset operation.
STEP 4: Tighten bolts that were loosened in Step 3 from the IUAB-301-1 assembly instructions.
STEP 5: Attach Lift Mechanism Power Box and Handset
(
“
5
”
and
“
6
”
on the component list for lift desk
mechanism) to the desired positions with screws (
“
A
”
on the hardware bag for lift desk mechanism).
STEP 6: Follow Step 5 from the IUAB-301-1 assembly instructins.
STEP 7: Clip the wire into the plastic wire clip, Attach the plastic wire clips(E) to the right position with screws(F).
STEP 8: Turn the assembled desk to the upright position.
STEP 9: Connect the appropriate wires leading from the motor and Handset to the Lift Mechanism Power Box.
STEP 10: Plug in the Power Box to an AC outlet.
STEP 11: If disassembly is required, lower the Lift Mechanism to the lowest point.
Lift Mechanism
Handset
Lift Mechanism
Power Box
Lift Mechanism
Handset
Lift Mechanism
Power Box
03-25-2022
ITEM NO: I256-360T Lift Desk Top
STEP 12: Reverse each knob by removing the screws while each drawer is open and attach
all knobs to the front of the drawers with screws as shown below.
Knob
Screw
Knob
