ASP motioncare LIANA, User Manual

Page: 13 / 50

Gebrauchsanweisung LIANA
| Version 1.0
Seite 13 von 50
6. INSTALLATION
The product is delivered in a ready-to-use condition.
6.1. Electrical connection
Before commissioning our devices, you should check your electrical installation in accordance with the applicable
VDE regulations 0100 and 0100-710. This regulation only applies in Germany. Other countries may have different
regulations.
Have the charging station installed by a qualified electrician in accordance with the regulations in force in your
country.
The socket outlet must comply with the regulations of VDE 0100 and 0100-710.
6.2. Initial commissioning
WARNING
The device may only be used in accordance with the accompanying documents.
The manufacturer will only assume responsibility for the impact on the safety, reliability and performance of
the device under these conditions.
If the product is newly connected, the technical information must be observed.
NOTE
Before initial commissioning, the battery must be fully charged (charging time before initial operation min. 12
hours).
To move the lift arm, please check that the emergency stop switch has been unlocked.
The LIANA sitting and standing stabilisation aid is equipped with two electric motors. These motors are self-locking
and thus secured against the lift arm being lowered in the event of a fault. The battery of the LIANA must be fully
charged before commissioning.
Please check whether the emergency stop switch is unlocked. To unlock, please turn the knob of the emergency
stop switch clockwise (to the right) until it unlocks.
NOTE
Also for safety reasons, the power supply has been disconnected if the door (battery- and powersupply) is
open.