8
explanation, please refer to
Network Configuration
chapter.
6. After finish the configuration for the very first time, if you want to use wireless network,
configure the wireless settings, then, plug out the Ethernet cable to use the wireless
connection.
Audio Connections
The terminal block inside of the camera provides audio functionalities. You can connect
the wires of connector to this terminal block to output these signals.
Audio Output
I/O Connections
The terminal block inside of the camera also Digital Input and Digital Output. You can
connect the wires of connector to this terminal block to output these signals. The I/O
connector used in application, for e.g., motion detection, event triggering, alarm
notifications. It provides the interface to:
1 set of Digital Input (Digital In + GND) – The digital inputs for connecting devices
that can toggle between an open and closed circuit, such as PIRs, door/window
contacts, glass break detectors, etc. When a signal is received the status changes
and the input becomes active.
1 set of Digital Output (Digital Out + GND) – The output to Relay Box or Relay
Board, and switch on the alarm device such as LEDs, Sirens, etc.
Digital Input (Alarm Input)
GND (Ground):
Initial status is LOW.
Alarm:
Max. 50mA, 3.3VDC.
Connects to an
amplified speaker
Summary of Contents for CAM6709H
