Askoll eB1L, User Manual, Page: 29 / 50

22
BATTERY AND RECHARGE
Battery installation on charger
Place the charger firmly on a flat and heat resistant
surface.
With battery charger powered install the battery on it,
install the battery on the charger inserting first tooth at
the bottom of the battery in the corresponding slot on
the charger.
After installing the battery, the charger will perform a
check on the remaining charge and all the warning
lights will light up for a few moments. After the check,
only the warning lights indicating the level of remaining
battery will be on and the remaining ones will flash (up
to the amount of charge of chosen charging mode).
Charging mode preset when feeding the battery
charger is always
TOTAL CHARGE , if the battery
charger remains connected to the mains once the
battery has been removed, the last charge mode set
will be saved and reused at the next charge.
Following a period of inactivity, if the battery is not
used or charged it will go to a standby state (minimum
consumption): if the battery is first connected to
the charger and then to the mains, you will need to
disconnect and reconnect the battery to reactivate
it and start charging. If the battery in standby is
connected to the charger already plugged in, it
will reactivate immediately and charging will begin
immediately.
eB3_Rev_0_EN.indb 22 eB3_Rev_0_EN.indb 22 4/6/2017 12:07:11 PM 4/6/2017 12:07:11 PM