3
Customer Care Center, 1-800-898-1879, www.askona.com
INSTALLATION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of
malfunction or breakdown, grounding will reduce the risk
of electric shock by providing a path of least resistance
for electric current. This appliance is equipped with a
cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
FREESTANDING INSTALLATION
The washer can be placed next to the dryer. It is
essential that the machine is leveled and the locknuts
are tightened to prevent excessive vibration during
spin cycles. Also be sure to leave a minimum of ½” of
space between the washer and the dryer. The height
adjustment for the washer is 33½” to 34½” (850 mm to
876 mm). Do not raise it higher than 34½” (876 mm).
WARNING
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check
with a quali
fi
ed electrician or serviceman if you are
in doubt as to whether the appliance is properly
grounded.
Do not modify the plug provided with the appliance. If
it will not
fi
t the outlet, have a proper outlet installed by
a quali
fi
ed electrician.
STACKED INSTALLATION
ASKO washers should never be stacked on a counter or
a dryer. You can, however, stack an ASKO dryer on an
ASKO washer. Refer to your Dryer Use and Care Guide
for instructions on how to do this.
BUILT
-
IN INSTALLATION
ASKO washers can be installed beneath a cabinet or
worktop with a height of 34” to 35” (863 to 889 mm) or
in a closet. There must be a gap of about ½” (12 mm) all
around the machine, including between the rear edge of
the machine’s top panel and the back wall. The opening
width must be at least 24½” (622 mm). Space must
also be available for the
fi
ll and drain hoses. See the
illustration below for measurements and positions. If the
washer is installed in a closet the door must be left open
while the washer is running.
If the drain outlet is higher than 24”(610 mm), the
connections will need to be recessed.
