4
out. Then press the
button to open the
door. To restart: fill with new detergent, if re-
quired, and select a new program.
OVERFILL PROTECTION
If the level of water in the machine rises above
normal, the overfill protection will start to pump
out water and shut off the water supply. The
program will be interrupted if the level does
not fall within 60 seconds.
PACKING MATERIAL
Sort the packing material for recycling accor-
ding to recommendations by the local authori-
ties.
TRANSPORT/WINTER STORAGE
If the machine is to be transported or stored in
unheated premises where the temperature can
drop below zero, you should adopt the follo-
wing procedure:
• Empty the needle trap and the drain pump;
see Chapter 10, Care and cleaning.
• Turn off the water supply to the washing mach-
ine, disconnect the supply hose to the inlet val-
ve, and allow the water to run out from the
valve and the hose.
DISPOSAL
Contact your refuse collection service or your
local authorities for advice on how to scrap the
machine in a proper manner for recycling.
The machine is made and marked to facilita-
te recycling.
GENERAL
• Study and save this Use and Care Guide for
future reference.
• Electrical and water installation, if required,
must be carried out by authorised persons.
• The machine may only be used for washing
in accordance with this Use and Care Guide -
not for dry cleaning.
• Use only detergents intended for machine
washing.
• Remove the transport supports before using
the machine, see installation instructions.
• Repairs and maintenance undertaken for re-
asons of safety and performance must be carried
out by authorised persons.
INSTALLATION
See the accompanying installation instructions.
WASHER DOOR
The door of the washer opens electrically. Con-
sequently, the door cannot be opened normally
until the machine is connected to an electric
power supply.
To open the door manually, see the heading,
Door will not open, in Chapter 11, Trouble
shooting.
The machine cannot be started with the door
open.
To open the door during operation, see be-
low, Interrupting a program.
INTERRUPTING A PROGRAM
To interrupt a washing program, press the
button for three seconds. If any water remains
in the machine, run either the Drain or the
Spin program. Any water will then be pumped
2 SAFETY INSTRUCTIONS
