18
Custumer Care Center
1-800-898-1879
www.askousa.com
Installation instructions
Positioning the tumble dryer
The tumble dryer can be installed free-
standing or stacked. Remember that the
tumble dryer produces heat and should
therefore not be located in a room that is
too small. If the room is very small, drying
will take longer due to the limited quantity of
air.
Caution!
The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
Advice!
To improve ventilation, the door to the room
where the tumble dryer is located should be
left open.
Caution!
Any electrical installation must be carried
out by qualified professionals.
A. Freestanding
The tumble dryer can be positioned beside
the washing machine.
B. Stacking
The tumble dryer can be placed on top of
a washing machine. To stack the dryer, you
need to the stacking attachments that come
with the machine. There will be:
2 foot cups. These can be found in a bag in
the drum.
2 anti-tip devices. These come attached to
the bottom left corner on the back of the
machine.
C. Built-in
ASKO dryers can be installed beneath a
cabinet or worktop with a minimum height
of 34” (864 mm). There must be a gap of
about 1/2” (12 mm) all around the machine,
including between the rear edge of the
machine top panel and the back wall. The
opening width must be at least 24-1/2” (622
mm).
Space must also be available for the ex-
haust hose on the left, right or rear of the
machine. See the diagram for hole sizes
and positions. Note that the hole measure-
ments are to the center of the hole.
How to install the stacking kit:
1
. Remove the two screws indicated on the
back of the washing machine.
2
. Secure the anti-tip device using the
screws as shown in the picture.
NOTES:
The height adjustment for the dryer is
33-1/2” to 34-1/2” (850 mm to 876 mm).
Do not raise it higher than 34-1/2”.
Hole measurements are from center of
hole.
