16
Customer Care Center, 1-800-898-1879, www.askousa.com
See the separate installation instructions
included in the set of documents.
CONNECTING TO THE POWER MAINS
After installation, the dryer should stand still for
two hours before it is connected to the power mains.
Connect the appliance to a grounded power outlet.
After installation, the wall outlet should be freely
accessible. The outlet should be
Þ
tted with an earth
contact (in compliance with the relevant regulations).
The receptacle on the rear of the machine is
designed to accommodate ASKO washers ONLY
(rated 208–240 V.) To use this receptacle, you must
use the ready
Þ
tted plug supplied with the washing
machine or anequivalent. ASKO washers rated
208–240 V have two internal fuses of 15 A each. The
machine should only be connected to a grounded
wall socket.
This appliance must be properly grounded.
Refer to the “Important Safety Instructions” for
grounding instructions. The power supply cord must
be grounded. If the machine is to be used in a wet
area, the supply must be protected by a residual
current device. Connection to a permanently wired
supply point must be made only by a quali
Þ
ed
electrician.
Connection upon delivery
TYPE: TDXX.XXXXX
Art.No.: XXXXXX/XX
Ser.No.: XXXXXXXX
MODEL: XXXXXX.X
XXXX W XXA
IPX4
X kg
XXX V ~
XX Hz
Information about your dryer is indicated on the
rating (type) plate.
Use the type A di
Ű
erential current protection switch.
The dryer shall not be connected to the power
mains using an extension cord.
Do not connect the tumble dryer to an electrical
outlet intended for an electric shaver or hair dryer.
Any repair and maintenance pertaining to safety
or performance should be done by trained experts.
