Asko R2303 Instructions For Use Manual Download Page 3

 This appliance must be properly connected to the 

electrical power supply (see: Connecting to the Power 
Supply).

 Always disconnect the appliance from power 

supply before replacing the light bulb, cleaning and/or 
attempting any repairs.

 When disconnecting the appliance from the wall 

outlet always hold the plug with your hand, and never 
pull the cord.

• 

The appliance is manufactured in compliance with all 
relevant safety standards; however, it is recommended 
that persons with impaired physical, motional, or mental 
abilities, or persons with inadequate experience and 
knowledge, do not use the appliance without due 
supervision. The same recommendation applies to 
minors using the appliance.

• 

For the sake of the environmental protection be careful 
not to damage the rear wall of the appliance or any 
part of the sealed refrigerating system when moving 
the appliance. 

• 

The refrigerating system on this appliance is filled with 
refrigerant and oil. If the appliance is damaged, handle 
it with care and dispose of it  in accordance with 
environmental protection requirements. (See Our Care 
for the Environment).

• 

If the power cord is damaged it may be replaced by the 
manufacturer, his service personnel or other qualified 
personnel only in order to avoid possible injuries.

• 

Changing the direction of door opening may also be 
performed by the after-sale service personnel only!

• 

Do not store flammable, vaporizing or explosive 
materials in the cooler, like for example explosives or 
sprays containing flammable substances like propane, 
butane, pentane, etc. Such sprays are clearly marked 
with adequate symbols for danger on the exterior of 
the package.

• 

Bottles with high alcohol content must be tightly sealed 
and stored in upright position.

• 

Warning:

 Ventilation slots on the appliance or built-in 

element should always be kept clean and unobstructed.

• 

Warning:

 Do not use any mechanical accessories 

when thawing the refrigerator, except for those 
explicitly recommended by the manufacturer.

• 

Warning:

 To prevent any pollution be careful not to 

damage the insulation or refrigeration tubes at the rear 
wall during the installation, cleaning and disposal of the 
appliance.

• 

Warning:

 Do not use any electrical devices inside the 

appliance, except for those explicitly recommended by 
the manufacturer.

The symbol on the product or on its packaging 

indicates that this product may not be treated as 
household waste. Instead it shall be handed over to the 
applicable collection point for the recycling of electrical 
and electronic equipment. By ensuring this product is 
disposed of correctly, you will help prevent potential 
negative consequences for the environment and human 
health, which could otherwise be caused by inappropriate 
waste handling of thisproduct. For more detailed 
information about recycling of this product, please 
contact your local city office, your household waste 
disposal service or the shop where you purchased the 
product.

Important

Summary of Contents for R2303













Reviews: