Asko HG1355gb, Instructions For Use Manual

Page: 14 / 24

Solution Possible cause Symptom
Keep the control knob fully depressed
for at least 3 seconds between high
and low settings. This can take longer
the first time because of the gas
supply. The control knob has not
been depressed long or
deep enough (at least 3
seconds). Burner extinguishes after
igniting.
Clean/dry the thermocouple. Thermocouple (2) is dirty.
Ensure that there is nothing on the
buttons. Ensure that the buttons are
clean and there is no water on them. There is an object, water or
dirt on the buttons.
Button used for too long. Timer indicates error code
F0 – F6 (if present).
Contact the technician if the error code
does not disappear.
Close the gas main switch and pull the
plug out of the socket. Contact your
installer. Ceramic glass plate broke
Please note! Do not throw a broken
ceramic glass plate in the glass
recycling bin but take this to the
Municipality's waste recycling centre.
Contact the service department. Other error codes.
Table continued from last page
14
Faults