Anti-tip feet
Built-in
1. Start by measuring the height from the floor to the bottom edge of the countertop.
2. Measure the height from the floor to the top edge of the dishwasher.
3. Adjust the dishwasher's feet by turning them clockwise to raise or counterclockwise to lower the
machine.
4. Verify there is an air gap of at least 1/8'' between the underside of the countertop and the top
edge of the dishwasher.
5. Tighten the lock nuts (lock nut) on the rear feet.
6. Slide the dishwasher into place.
•
Pull the supply and drainage hoses when sliding the dishwasher into place.
•
Check that the hoses have no kinks or sharp bends, and check that there is nothing that
can damage the hoses.
7. Make any final adjustments to the front feet (the dishwasher may lean no more than 1/4'') and
tighten the lock nuts.
8. Once the feet are properly adjusted, tighten the anti-tip feet firmly against the floor.
Drain connection
The high loop is necessary for proper draining. Therefore, the dishwasher has the drainage hose
attached to the top back of the unit. This gives the drainage hose an automatic high loop. The
drainage hose is fastened at the best high loop height.
36
Installation instructions
