WARNING!
Hard water leaves a white coating on dishes and inside the dishwasher. It is therefore important
that you select the right setting for the water softener! See Water hardness.
Never run the dishwasher with an empty salt compartment if the water supply has a water hardness
in excess of 5°dH (9°fH / 6°eH / 0.9 mmol/l).
Basic settings
Lightly press the middle of the upper part of the door to open the dishwasher. Press
.
"
Welcome to your new ASKO dishwasher. This is a first time setup.
" is shown on the display. It
is important that you choose the right settings to ensure good dishwashing results.
Select setting with
or . Confirm selected setting with
.
Settings
Select the language to be shown on the display.
Language
1.
Drying is faster and a better result is achieved if you use
rinse aid. You will also achieve a better dishwashing result
with clear and spotless dishes.
Rinse aid
0/1/2/3/4/5
2.
The rinse aid dispenser can be adjusted between 0 (Off)
and 5 (High dosage).
Pre-selected at factory: 4
Adjusting the water softener. Select a setting depending on
the hardness of the water supply. It is important that this
setting is correct!
Water hardness
0/1/2/3/4/5/6/7/8/9
3.
For a water supply with a hardness below 6°dH (10°fH /
7°eH / 1.0 mmol/l), select 0. The water softener is deactivated
and no salt needs to be added.
Pre-selected at factory: 4
Activate this setting when using an all-in-one detergent that
contains rinse aid.
TAB
On/Off
4.
This setting reduces the rinse aid dosage.
Pre-selected at factory: Off
Activate this setting if you want to use automatic detergent
dispensing.
Auto dose
0 ml - 40 ml
5.
The exact dosage depends on which program is running.
For the Auto program, the dosage also depends on how
dirty the dishes are.
Pre-selected at factory: 0 ml (Off)
To change the selected setting, see the chapter Settings.
7
Before washing for the first time
