Troubleshooting
Action
Type of fault on the display
Clear the drain pump. See the chapter Care and maintenance instructions. If the problem persists,
call the Customer Care Center.
Overfilling water 1
F10
See “Water remains in the dishwasher above the filters” in the table “Problem” below. If the
problem persists, call the Customer Care Center.
Water outlet fault
F11
Check that the water supply valve is on. If the problem persists, call the Customer Care Center.
Water inlet fault
F12
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and call the Customer Care Center.
Inlet valve leakage
F40
Clean the coarse and fine filters. If the problem persists, call the Customer Care Center.
Water level fault
F52
Turn off the water supply valve and call the Customer Care Center.
Overfilling water 2
F54
Call the Customer Care Center.
Circ. pump fault
F56
Press any button to clear the error message.
Action
Possible causes
Problem
Wait a moment then try again.
You have pressed the buttons too soon after
opening the door.
The buttons do not react when pressed.
See the chapter Settings.
Child lock (button lock) activated.
Open the door. The buttons only react to use
when the door is open.
The door is closed.
Clean with a dry or slightly damp cloth.
The buttons are dirty.
Check that the baskets are correctly positioned
horizontally, and that the middle basket's water
connector is in line with its spray pipe.
The baskets are not correctly positioned.
Cannot close door.
Check that the dishes are not blocking the
baskets from sliding properly into place.
Press and hold Start/Stop until the display shows
"Program started, close door in 4 sec".
The Start/Stop start button has been pressed
for too short a time.
The dishwasher does not start.
Close the door within four seconds, otherwise
the dishwasher will not start.
The door is not closed properly or was not
closed immediately after pressing the Start/Stop
button.
If you want the dishwashing program to
continue, press Start/Stop and close the door
within four seconds.
You have opened the dishwasher to add more
dishes while a program is in progress.
Check.
A fuse/circuit breaker has been tripped.
Check.
The plug is not plugged into the power outlet.
Check.
The water supply valve is turned off.
Check.
Overflow/leaks.
Turn off the water supply valve. Pull out the plug
and call the Customer Care Center.
A whirring sound (the drain pump) is heard from
the dishwasher and does not stop when the
main power switch is turned off.
Press and hold Start/Stop for three seconds if
you want to cancel the Delayed Start option.
Check that the Delayed Start option has not
been selected.
16
