Asko DFI444B, Operating Instructions Manual

Page: 19 / 28

Action Possible causes Problem
Clean the coarse and fine filters. The filters are blocked. Water remains in the dishwasher.
Check that the filter handle is locked in the stop
position. The handle should point straight out
from the dishwasher. The filters are not fitted correctly.
Clean the drainage pump. See the chapter Care
and cleaning. Debris in the drainage pump.
Check that the coloured stop on the right in the
bottom drain is in place. See the chapter Care
and cleaning. Drainage pump stop missing.
Check that the hose is free from kinks and sharp
bends. Kink in drainage hose.
Disconnect the drainage hose where it connects
to the sink unit's water trap. Check that no debris
has fastened and that the connection has an
inner diameter of at least 14 mm. Blocked drainage hose.
Clean with washing-up brush and low foaming
cleaner. Dirt around the seals and in corners. Bad odour in dishwasher.
Run a programme with a higher temperature
once or twice a month. Low temperature programmes have been
selected for a prolonged period.
Activate the Auto Open option. The Auto Open option is not activated. The dishes are not dry enough.
Fully load the dishwasher. The dishwasher is not fully loaded.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings. Rinse aid needs topping up or dosage is set too
low.
Switch all-in-one detergents or deactivate the
setting TAB and top up with salt and separate
rinse aid. See Rinse aid in the chapter Settings. The setting TAB is activated and all-in-one
detergent with insufficient drying effect is being
used.
19