Action
Type of fault on the display
Clear the drain pump. See the chapter Care and maintenance
instructions. If the problem persists, call the Customer Care Center.
Overfilling water 1
F10
See “Water remains in the dishwasher above the filters” in the table
“Problem” below. If the problem persists, call the Customer Care
Center.
Water outlet fault
F11
Check that the water supply valve is on. If the problem persists,
call the Customer Care Center.
Water inlet fault
F12
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and call the Customer Care Center.
Inlet valve leakage
F40
Clean the coarse and fine filters. If the problem persists, call the
Customer Care Center.
Clean the filters
(Water level fault)
F52
Turn off the water supply valve and call the Customer Care Center.
Overfilling water 2
F54
Call the Customer Care Center.
Circ. pump fault
F56
Check that the water supply valve is on. If the problem persists,
call the Customer Care Center.
Water inlet fault
F67
The water pressure should be 4.2-140 psi.
Press any button to clear the error message.
Action
Possible causes
Problem
Wait a moment then try again.
You have pressed the buttons
too soon after opening the door.
The buttons do not react when
pressed.
See the chapter Settings.
Child lock (button lock) activat-
ed.
Open the door. The buttons only
react to use when the door is
open.
The door is closed.
Clean with a dry or slightly damp
cloth.
The buttons are dirty.
Check that the baskets are cor-
rectly positioned horizontally,
and that the middle basket's
water connector is in line with its
spray pipe.
The baskets are not correctly
positioned.
Cannot close door.
Check that the dishes are not
blocking the baskets from slid-
ing properly into place.
29
Troubleshooting
