Asko DBI675 XXLS, Operating Instructions Manual

Page: 14 / 28

Care and maintenance
instructions
Add rinse aid
When the rinse aid needs topping up, the above symbol lights on the
display.
Press to open
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked max .
3. Wipe up any spilled rinse aid around the compartment.
4. Close the lid firmly.
After topping up, it may take a while before the symbol goes out.
Coarse filter
The coarse filter traps larger food particles, which cannot get past the
drain pump. Empty the coarse filter when necessary.
Coarse filter
1. Lift the coarse filter by the handle.
2. Empty the coarse filter. Remember to reinstall it!
Fine filter
Debris that collects on the fine filter is automatically rinsed away during
each wash. Clean the fine filter when necessary.
Fine filter
1. Turn the handle counterclockwise.
2. Lift the filter straight up using the handle. Remove the coarse filter
to clean the fine filter.
3. Reinstall in reverse order. Check that the edges seal properly when
reinstalling the fine filter.
4. Lock the filter in place by turning the handle clockwise to the stop
position. The handle should point straight out from the dishwasher.
NOTE!
Dishwashing results may be
affected if the filters are incorrectly
fitted. Note that the dishwasher
must not be used without the filters
in place!
NOTE!
Check that the colored stop on the
right in the bottom drain is in
place.
Spray arms and spray pipes
Holes and bearings can become blocked. Remove debris using a
needle or similar item. The spray arms have holes on the bottom.
Spray arms can be removed for cleaning. Remember to fit them firmly
back into place afterward.
Upper spray arm
1. Pull out the upper basket.
2. Unscrew the spray arm bearings counterclockwise to remove the
spray arm from the upper basket.
The middle spray pipes
• Pull out the middle basket.
• Check the holes in the spray pipes.
14