Asko DBI664, Operating Instructions Manual

Page: 15 / 28

Lower spray arm
• Pull the lower spray arm straight up to release it.
The door and the door seal
Regularly clean the sides of the door and the door seal. Use a slightly
damp cloth (with a little cleaner if necessary).
Display panel
Keep the buttons clean and free from grease. Wipe them clean with a
dry or slightly damp cloth. Never use cleaners – they can scratch the
surface. Use the main power switch to turn off the dishwasher before
cleaning the buttons to avoid activating any buttons unintentionally.
The dishwasher tub
The dishwasher tub is made of stainless steel and is kept clean through
normal use.
Limescale deposits
If you have hard water, limescale deposits may build up in the
dishwasher. If this happens, run the Self-cleaning program with two
tablespoons of citric acid in the detergent compartment (with no dishes
in the machine). Special dishwasher cleaners are also available in
stores.
Never use anti-freeze, Draino
®
, CLR
®
, or other chemical cleaners.
Unblocking the drain pump
If the dishwasher still contains water after the program has finished,
something may be blocking the drain pump. Such items are easily
removed.
1. Turn off the machine using the main power switch and unplug it
from the power outlet.
2. Remove the coarse filter and the fine filter.
3. Scoop out the water from the dishwasher tub.
4. In order to inspect the drain pump, remove the colored stop on the
right in the bottom drain.
5. Turn the pump wheel located behind the drain pump stop by hand.
Carefully remove any items.
6. Reinstall the drain pump stop along with the fine and coarse filters.
7. Plug the machine in again.
If the dishwasher still does not start and a whirring sound is heard,
the overflow protection has been triggered.
• Shut off the water.
• Unplug the unit from the power outlet.
• Call the Customer Care Center.
Drain pump stop
NOTE!
Do not forget to reinstall the drain pump stop.
15