Asko DBI664 XXL, Operating Instructions Manual

Page: 10 / 24

1 Press the button once to activate Delayed Start. Press the button
several times – or hold it in – to set the desired number of hours.
2 Press Start/Stop and close the door. The timer counts down and
the dishwasher starts after the selected delay.
If you want to cancel the Delayed Start option, open the door and press
and hold the main power switch until the display turns off.
TIP!
Activate the setting High temperature to improve the dishwashing
results. Energy consumption is slightly increased.
START
STOP
Starting the dishwasher
Press and hold Start/Stop until the display shows "Program started,
close door in 4 sec". This indicates that the dishwasher is ready to
start. Close the door properly within four seconds, otherwise the
dishwasher will not start.
If the dishwasher is not started or the door is not closed within 2 minutes
of the last button press, the machine switches off.
Time remaining
Once you have chosen a program, program mode, and options, the
time the program took when last used is displayed.
Status light™
Status light
The status light at the bottom on the dishwasher provides information
by means of 3 different colors.
Blue - Do not load
The program has started.
Red - Do not load
The detergent compartment lid has been opened to add detergent.
Flashing red indicates a problem. See also the chapter Troubleshooting .
Green - Unload
The dishwashing program is finished. Standby light for 60 minutes.
Stopping or changing a program
If you want to change the program after starting the dishwasher, open
the door then press and hold Start/Stop for three seconds. Add more
detergent if the lid of the detergent dispenser has opened. Then choose
a new program, press Start/Stop, and close the door within four
seconds.
WARNING!
The dishwasher door must not be open while a program is in progress
according to UL Standards. If the door is opened, "Program paused"
is shown on the display. If you want the dishwashing program to
continue, press Start/Stop and close the door immediately. If you
want to cancel the dishwashing program, press and hold the main
power switch until the display turns off.
If the dishwasher is turned off due to a
power failure
If the program was not finished, the interrupted program resumes when
power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or the
door is open for more than 2 minutes.
Once the program has finished
Once the program has finished and the door is opened, "Ready"
appears on the display.
At the end of the program, one short signal will sound. Chapter Settings
describes how to change this function.
Moreover, the end of the program is indicated by the status light turning
green.
The dishwasher switches off automatically after the program ends.
To minimize the risk of leaks, we recommend that you turn off the water
supply valve if away from home for an extended period of time.
How to get the best drying results
• Fully load the dishwasher.
• Angle dishes with hollows, such as cups, so that the rinse water
will run off. This is also important for plastic items.
• Top up with rinse aid or increase the rinse aid dosage level.
• Activate the Extra Dry option.
• Open the door a little once the program has finished.
• Allow the dishes to cool before unloading the dishwasher.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher
before unloading them.
Unload the lower basket first to avoid any water drops from the upper
basket falling onto the dishes in the lower basket.
10