You can vary the temperature as shown below:
130 °F (55 °C) / 160 °F (70 °C)
Heavy wash:
130 °F (55 °C) / 150 °F (65 °C)
Normal wash:
140 °F (60 °C)/150 °F (65 °C)
Daily wash:
85 °F (30 °C) / 140 °F (60 °C)
Quick wash:
85 °F (30 °C) / 140 °F (60 °C)
Super Quick wash:
105 °F (40 °C) / 120 °F (50 °C)
Delicate wash:
120 °F (50 °C) / 140 °F (60 °C)
Eco wash:
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can be
used with all programs except Rinse & Dry, and Rinse & Hold.
If you want a program with Short dry, press again so that the field
under the button turns off.
START THE DISHWASHER
Press and hold Start/Stop until the display shows
(the door
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
The display flashes three times with the remaining time to indicate
that the program has started.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.
TIME REMAINING
Once you have selected a program and options, the display
indicates how long the program took the last time it was used.
Once you have started the dishwasher, the display indicates how
much program time remains. The remaining time is updated after
the water for the final rinse has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature, and other factors.
The time counts down while the program is running and the
remainder of the program is displayed. The remaining time is
displayed, e.g., 1:15, meaning that 1 minute 15 seconds of the
program remains.
NOTE!
During the first run of each program, the remaining time
displayed can be slightly misleading, as the dishwasher is estimating
the time. When you run the program a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the program.
STOPPING OR CHANGING A PROGRAM
If you want to change programs after starting the dishwasher, open
the door then press and hold Start/Stop for three seconds. Add
more detergent if the lid of the detergent dispenser has opened.
Then choose a new program, press Start/Stop, and close the door.
DO YOU WANT TO ADD MORE DISHES?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door, and the dishwasher resumes the program.
IF THE DISHWASHER IS TURNED OFF USING
THE ON/LEFT-ON MODE BUTTON OR DUE TO
A POWER FAILURE
If the program was not finished, the interrupted program resumes
when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
ONCE THE PROGRAM HAS FINISHED
Once the program has finished, "End" appears on the display.
A buzzer also sounds at the end of the program. See the section
Settings, which describes how to change this function.
Once the dishwasher has finished, it uses only standby power. Turn
off the water supply valve after each use.
Customer Care Center 1-800-898-1879
www.askona.com
9
