Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can be
used with all programs except Time program, Rinse & Dry, and
Rinse & Hold. This option cannot be activated if the Time saver
option is selected.
If you want a program with Short dry, press again so that the field
under the button turns off.
Delayed start
When you select Delayed start, the dishwasher will start 1-24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at a
time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the program.
Set time
Press the option button several times – or hold it in – to set the
desired program time for Time program. You can choose a
program time between 30 minutes and 3 hours.
Time saver
This option shortens the program time, but uses more energy and
water. This option can be selected with the Heavy wash, Normal
wash, Daily wash, Upper half, Lower half, and Mixed wash
programs.
START THE DISHWASHER
Press and hold Start/Stop until the display shows
(the door
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.
TIME REMAINING
Once you have selected a program and options, the display
indicates how long the program took the last time it was used. The
remaining time is updated after the water for the final rinse has
been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature, and other factors.
NOTE!
During the first run of each program, the remaining time
displayed can be slightly misleading, as the dishwasher is estimating
the time. When you run the program a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the program.
STATUS LIGHT™
The status light at the bottom on the dishwasher provides
information by means of 3 different colors. Adjust the status light
so that it is seen clearly by pulling out or pushing in the transparent
plastic strip.
Status light
Blue
Load more. The program has started, but you can still load more
dishes.
Red
Do not load. You should not load more dishes (risk of poor
dishwashing result).
Flashing red
This indicates a fault. See further in the section Troubleshooting.
Green
Unload. The dishwashing program is finished. Standby light for two
hours.
STOPPING OR CHANGING A PROGRAM
If you want to change programs after starting the dishwasher, open
the door then press and hold Start/Stop for three seconds. Add
more detergent if the lid of the detergent dispenser has opened.
Then choose a new program, press Start/Stop, and close the door.
DO YOU WANT TO ADD MORE DISHES?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door, and the dishwasher resumes the program.
Customer Care Center 1-800-898-1879
www.askousa.com
10
