Installation
519
1229
550
30-94
596
573
550
5
4
3
7
7
7
0
0
-8
0
0
30
7
1
0
1
9
5
4
4
4
49
7
4
0
8
6
1
-
9
1
2
1
3
3
-1
8
3
[mm]
*Remove locking nuts for an installed height of
860-861 mm.
**Door length.
It is important that you read through and follow the instructions
and directions below. Conduct installation and connection in
accordance with the separate installation instructions.
Safety instructions
• Connections to electricity, water and drainage must be
performed by a qualified professional.
• Always follow applicable regulations for water, drainage and
electricity.
• An incorrect or flawed installation can result in higher
consumption of energy, water and detergent, which can result
in increased costs and poor dishwashing results. In order to
minimise noise it is important that you follow the instructions.
• Take care during installation! Wear protective gloves! There
must always be two people!
• Before screwing the dishwasher into place, test the dishwasher
by running the Rinse & Hold program. Check that the
dishwasher fills with water and drains. Check also that none
of the connections leak.
WARNING!
Turn off the water supply when installing the dishwasher!
WARNING!
The plug must be disconnected or power to the socket turned
off while the work is carried out!
Setup
• The recess and connection dimensions are included in the
separate installation instructions. Check that all dimensions
are correct before starting the installation.
• Make sure the area on which the dishwasher is to be installed
is firm. Adjust the adjustable feet so that the dishwasher is
level. Tighten the lock nuts.
• Stronger door springs are available for purchase for
dishwashers with a fitted wooden door. Springs are available
for various weights and sizes of wooden door. Door springs
can be purchased from the retailer who sold you the
dishwasher.
Drainage connection
See the separate installation instructions for all necessary
information.
The drainage hose may be extended by a maximum of 3 m (the
total length of the drainage hose must not exceed 4.5 m). Any
joins and connecting pipes must have an internal diameter of at
least 14 mm. However, the drainage hose should ideally be
replaced with a new hose without joins.
No part of the drainage hose may be more than 950 mm above
the bottom of the dishwasher. The hose must not be routed
directly to a floor drain or the like. In such cases, the hose can
act as a siphon and empty the dishwasher.
The hose must always discharge at least 350 mm above the
bottom of the machine.
Ensure that the drainage hose has no kinks.
NOTE!
The hose must be attached at the same height as the underside
of the sink.
19
Summary of Contents for D5544 XXL FI
Page 22: ...Your notes 22 ...
Page 23: ...Your notes 23 ...
