Quick
This program is used for glasses and porcelain that is lightly
soiled, such as coffee cups.
Super Quick
Short program lasting about 15 minutes with acceptable results
for very lightly soiled dishes.
Delicate
If the dishes are only lightly soiled, you can select Delicate. This
program is intended for glasses and porcelain that have just been
used and as such do not require such a powerful program.
This program can be used for fragile dishes. Select Short dry if
you want to be especially cautious. See also the section Fragile
dishes in the chapter Loading the dishwasher.
Eco
Use when you want to save energy. For normally soiled dishes.
Rinse & Dry
This program consists of a rinse with heating and drying. This is
a suitable program if, for example, you plan to make jam and
want to rinse and heat clean glass jars.
Rinse & Hold
Use to rinse dishes while you wait for the dishwasher to become
fully loaded.
Selecting Options
To select an option, press one of the option buttons. The field
under the button lights when the option is activated. The available
options depend on the selected program. Once you have started
the program, the options you selected are saved for the next time
you use the same program. An exception is the Delayed start
option.
High temperature
Activate this option for improved dishwashing results. The
machine then uses a higher temperature for the main wash.
If you want to use the lower temperature, press again so that the
field under the button turns off.
You can vary the temperature as shown below:
130 °F (55 °C) / 160 °F (70 °C)
Sanitation:
130 °F (55 °C) / 150 °F (65 °C)
Normal:
140 °F (60 °C)/150 °F (65 °C)
Heavy:
85 °F (30 °C) / 140 °F (60 °C)
Quick:
85 °F (30 °C) / 140 °F (60 °C)
Super Quick:
105 °F (40 °C) / 120 °F (50 °C)
Delicate:
120 °F (50 °C) / 140 °F (60 °C)
Eco:
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option.
This causes a slight increase in energy consumption. This option
can be used with all programs except Rinse & Dry and Rinse &
Hold.
If you want a program with Short dry, press again so that the field
under the button turns off.
Delayed start
When you select Delayed start, the dishwasher will start 1-24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at
a time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the program.
Start the dishwasher
Press and hold Start/Stop until the display shows
(the door
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.
Time remaining
Once you have selected a program and options, the display
indicates how long the program took the last time it was used.
The remaining time is updated after the water for the final rinse
has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature, and other factors.
Customer Care Center 1-800-898-1879
www.askona.com
8
