Stopping or changing a program
In order not to accidently press a button and cancel the current
program, you must press and hold Start/Stop for five seconds if
you want to change programs after starting the dishwasher. Add
more detergent if the lid of the detergent dispenser has opened.
Then choose a new program and press Start/Stop.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the program.
If the dishwasher is turned off using
the main power switch or due to a
power failure
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
Once the program has finished
Once the program has finished, “End” appears on the display.
At the end of the program, you will hear a short beep. Chapter
Settings describes how to change this function.
Once the dishwasher has finished, it only uses standby power.
Turn off the dishwasher with the main power switch if you want
to cut the power completely. Shut off the water tap after every
use.
Drying
For additional drying the door should be opened 35 mm upon
completion of the drying cycle. For more information, see page
16 in the chapter Technical information.
8
