Asko D3230, Use And Care Manual

Page: 20 / 40

20
Rinse aid
Pour in rinse aid
Rinse aid, helps quicker the drying process.
When the rinse aid runs out, the rinse aid
symbol lights up on the panel.
* Certain machines do not have this func-
tion. There is a refill indicator in the middle
of the dispenser (see picture). If the refill
indicator is totally black, there is sufficient
rinse aid. However, if the indicator has a
more transparent appearance, you need to
top up with rinse aid.
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser.
This is where you top up and set the
amount of rinse aid to be dispensed in each
wash.
2. Fill until the indicator is totally black and
change the dosage as follows if required.
Do not forget to close the cover.
Select dosage
The dispenser is usually set at 1= soft water.
However, depending on the water hard-
ness, it may be necessary to change the
dosage.
Open the rinse aid cover . Here you will find
the dispenser’s adjustment dial. Settings 1-6:
the harder the water, the higher the dosage.
When the water hardness exceeds 10-12
o dH
you should use rinse aid with citric acid (acid
rinse aid) if the machine does not have a water
softening filter. If the machine has a water
softening filter, dispense as for soft water.
Too much rinse aid can lead to the build-up
of foam. If your water is particularly soft, you
can dilute the rinse aid (1 part rinse aid, 1
part water).
Too much rinse aid can cause streaks on
the dishes, while too little can result in water
stains.
Once the rinse aid has been used up, the
rinse aid symbol will light up on the panel.*
Open
Closed
Refill indicator
Cover for rinse aid
Open by turning and lifting the cover!
*NB!
After filling there may be a short delay
before the signal light goes out.