background image

8

Customer Care Center, 1-800-898-1879, www.askousa.com

INSTALLATION AND CONNECTION

  

  After installation, wait for 24 hours without moving 

the appliance before using it for the 

fi

 rst time. If the 

dryer has to be laid down on one of the sides during 

transport or servicing, place it with its left side, viewing 

from the appliance front, downwards.

90°

90°

90°

90°

DRYER PLACEMENT

The dryer can be either free standing or installed on 

top of a washing machine. 

The dryer emits heat. Therefore, do not place it in 

a very small room, as the drying process may be 

longer due to limited amount of ambient air.

  Do not place the dryer in a room where 

temperature can drop below 0 °C, as the machine 

may not operate correctly at such low temperatures, 

or freeze, which in turn can result in damage to the 

machine.

For optimum dryer operation, install it in a room with 

adequate ventilation and a temperature between 

10 °C and 25 °C.

  Do not place the dryer behind lockable or sliding 

door, or door with a hinge on the opposite side of the 

dryer door hinge. Install the dryer in such way that 

the door can always be freely opened.

  Never block the air vents.

  At least two persons are required to install the 

tumble dryer on top of a washing machine.

  Do not place the dryer on a carpet with long 

fi

 bres as this may impede air circulation.

Free-standing appliance

The dryer may be placed adjacent to a washing 

machine.

If the friction between the dryer feet and the 

fl

 oor is 

not su

  cient, the dryer may move during operation. 

To prevent sliding, use a non-slide mat or install the 

supplied vacuum feet onto both front feet.

Place the dryer so that it is stable. Use a spirit 

level to level the dryer in longitudinal and traverse 

direction by rotating the adjustable feet using a No. 

22 spanner (max. 15 mm). Then, 

fi

 rmly tighten the 

jam nuts (counter nuts) by rotating them towards the 

appliance bottom using a No. 17 spanner 

.

Summary of Contents for Classic T208H








Reviews: