Panel key operation instructions:
1. Select transmission rate: When the rate switch is selected at "HIGH," the product works in
high rate mode, the RX has the best picture quality. If the rate switch is selected at "LOW", the product
works in low rate mode, the RX has the best working distance at the moment.
2. Change Wireless channel: Press the “CHANNEL” key on the front panel of TX to cyclic switch
the multiple wireless channels. If the product works unsteadily or pictures not fluent, You can try a
different working channel.
3. Restore Factory Setting: To press the button for lasting three seconds, then the HDMI Status
Led Light will flash for three times and restart, it shows that Restore Factory Set is successful.
The Factory Reset Button is located at the bottom of the Hole of the IR IN/OUT. It is able to work
under power on status. To use one long and narrow insulated stick (like toothpick) to insert the hole
end to press the button.
Note: You must to restore factory set at transmitter and all receivers before they can be reused.
Web settings:
To prevent the interference caused by the same frequency device, the Wireless HDMI Extender
support to set up the transmit channel and SSID by the WEB. For safety, the user should change the
SSDI and the password at the first log in. Please follow the below steps:
1. Connect 5V power supplies to the
transmitter and all receivers,
and let them be connected.
2. Turn on the WLAN of the mobile phone / PC
，
search and connect SSID
：
xxxx_HDMI_Wireless,
Enter the default password: 00000000
.
3. Modify the IP address type of the mobile phone / PC to Auto. When you select static type, you must
be set the IP in 192.168.1. xxx address segment range, e.g. 192.168.1.100.
4. Open the browser and scan the QR code or enter “192.168.1.10”
in the address bar to enter the configuration page.
.
As shown below:
