ashtech Reliance FS/2, Operation Manual

Page: 118 / 186

102 Reliance with FS/2 Field Operations Manual
RTCM Rover Station Screen (ROVR)
Use the RTCM ROVER STATION screen, Figure 4.28, to set parameters for the
RTCM rover station.
Table 4.23 describes the RTCM ROVER STATION screen fields.
Figure 4.28: RTCM Rover Station Screen (ROVR)
Table 4.23: RTCM Rover Station Screen Field Descriptions
Field Description
AUTO DIFFERENTIAL Toggle ON to use autonomous position if RTCM corrections are not
available (ON), or OFF to stop computing position when RTCM
corrections are not available (OFF).
BASE STATION ID Enter four character ID for base station. Valid values are 0-1023. Default
is 0. ID is sent out with differential corrections from base station.
If receiver operates as a remote station and this value is zero, the receiver
accepts differential corrections from any base station. If receiver operates
as a remote station and this value is not zero, the receiver accepts
differential corrections only from base station with the same ID number.
RADIO INPUT Remote station only. Port for collecting of differential corrections. Values
include: PORT A, PORT B, and PORT C. Default: PORT B.
BAUD RATE Communication rate between receiver and RTCM radio. Values include:
300, 600, 1200, 2400, 4800, 9600, 19200 and 38400. Default: 9600
MAXIMUM AGE Remote station only. Maximum age of a correction to use for correction.
Possible values are 0—999 seconds. Default: 20