ashtech HDS800, Reference Manual

Page: 77 / 678

61
Using the Web Server
• At the bottom of the page, in the
Differential Port
pane,
select the
Automatic
option to let the receiver detect the
incoming differential stream automatically.
NOTE:
Automatic
is the recommended choice for the
Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.
• Click on the
Configure
button to let the Web Server load all
your new parameters to the receiver. You just have now to
define the output messages (see
Defining Output
Messages on page 63 ).
RTK Corrections
Received on Port
A, B or F
• Unless already done, please follow all the steps described
in section
General Parameters on page 48 before
proceeding with the steps below.
• Still on the
Rover Setup
page, in the
Serial Port x
pane
corresponding to the port you want the receiver to use (A,
B or F), set the following parameters:
–
Connection
: Choose the name of the corrections
receiver device connected to the port. As a general
rule, choose “None/Cable” for any external corrections
receiver connected to that port. But if the device used
is a license-free radio, type ARF7474B EU or
ARF7474A NA, choose specifically this type of radio.
– Port settings (
Baud Rate
,
Mode
,
RTS/CTS
): Set the serial
port to match the external device connected to it.
Setting these fields will update the corresponding
fields on the
Serial Ports
sub-menu page
• At the bottom of the page, in the
Differential Port
pane,
select the
Automatic
option to let the receiver detect the
incoming differential stream automatically.
NOTE:
Automatic
is the recommended choice for the
Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.
RTK Corrections
A, B , F
HDS800