ashtech HDS800, Reference Manual

Page: 73 / 678

57
Using the Web Server
• Click on the
Connections
menu and then on the
Bluetooth/
Modem
sub-menu.
• Set the following parameters in the
Internal Modem/Device
Settings
pane:
–
Power
: Select “On”. Then choose whether the modem
should be turned on automatically or manually:
Automatic
: The modem will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual
: The modem will be powered up only by going
through the
Connections
>
Bluetooth/Modem
page and
setting the modem to “Power On” (or using the
$PASHS,MDM,ON command).
–
Automatic Connection
: Check this option.
–
Pin
: 4- to 8-character pin code of the SIM card used in
the modem for GPRS operation.
–
2G Only
: Recommended to save power.
• Set the following parameters in the
Internal Modem/GPRS
Mode Settings
pane (the mobile communication provider
you are using should be able to give you all this
information):
–
Internet Protocol
: Choose the Internet protocol (TCP or
UDP) allowing the modem to perform an Internet
connection.
–
Access Point
: Enter the URL of the mobile
communication provider.
–
Access Point Login
: Enter the login of the mobile
communication provider.
–
Password
: Enter the password of the mobile
communication provider.
• Click on the
Configure
button.
• Now please follow all the steps described in section
General Parameters on page 48 and then proceed with the
steps below.
• Still on the
Rover Setup
page, in the
Network
pane, set the
following parameters:
–
Connection
: Choose “Modem Ntrip Client - Port E”. As
a result, new fields appear in this pane that you should
set as instructed below:
–
Connect Now
: Enable this option to allow the receiver to
establish the connection right after you have clicked
on
Configure
.