ashtech HDS800, Reference Manual

Page: 67 / 678

51
Using the Web Server
• You can now click on the
Configure
button to save all the
changes made but remember you have to complete the
content of this page depending on how the receiver will
get its RTK corrections. Several typical applications are
listed below and described one after the other in the next
sections:
– Internal radio
– Direct IP via modem
– Direct IP via Ethernet
– NTRIP client via Ethernet
– RTK corrections received on port A, B or F
– Rover operating in Flying RTK mode.
– Rover operating in Hot Standby RTK.
Internal Radio
• Unless already done, please follow all the steps described
in section
General Parameters on page 48 before
proceeding with the steps below.
• Still on the
Rover Setup
page, read the content of the
Internal Radio Port D
pane. Normally, the content of the
read-only
Connection
field has been updated when opening
the
Rover Setup
page to report the type of internal radio
module currently used by the receiver (ADL Foundation).
Just check that this field reads the name of the expected
type of radio.
• Click on the
Power On
option to ask for radio power-up.
• At the bottom of the page, in the
Differential Port
pane,
select the
Automatic
option to let the receiver detect the
incoming differential stream automatically.
NOTE:
Automatic
is the recommended choice for the
Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.
Internal
Radio
HDS800
RTK Corrections
(UHF radio link)
Base Radio