ashtech HDS800, Reference Manual

Page: 432 / 678

416
Set Command Library
TCP,PAR: TCP/IP Server Settings
Function
This command is used to set the TCP/IP server.
Command Format
Syntax
$PASHS,TCP,PAR[,MOD,s1][,LGN,s2][,PWD,s3][,PRT,d4][*cc]
Parameters
Example
Enabling TCP/IP connection with authentication (login:
BX312, password: xwsead):
$PASHS,TCP,PAR,MOD,1,LGN,BX312,PWD,xwsead*1A
Comments
• When the TCP/IP server is enabled (s1=1 or 2) and the
receiver is connected to a network via the Ethernet cable,
an external device can open the port specified as
d4 and
communicate with the receiver. In this case, the current
port is port “I” in the receiver.
• When s1=1, the receiver does not accept any incoming
data or commands until it receives the login and the
password (see $PASHS,TCP,UID). It will however output
those messages that are programmed on port “I” even if it
has not received authentication yet.
• The default login is “ashtech” and the default password is
“password”.
• Both login and password are case sensitive.
Relevant Query
Command
$PASHQ,TCP
See also
$PASHS,TCP,UID
Parameter Description Range
MOD,s1
TCP/IP connection mode:
• 0: Disabled
• 1: Enabled with authentication
• 2: Enabled without authentication (default)
0-2
LGN,s2 Login 32 characters max.
PWD,s3 Password 32 characters max.
PRT,d4 Port number. Default is “8888” 100-65535
*cc Optional checksum *00-*FF