ashtech HDS800, Reference Manual

Page: 278 / 678

262
Set Command Library
Parameters
Examples
Entering the vertical measurement (2 m) of a rover antenna:
$PASHS,ANT,0,0,2.000*2E
Entering the slant measurement (1.543 m) of the
MAG111406 antenna used at a base:
$PASHS,ANT,1.543,0.0921,-0.0516*0A
Comments
• The vertical height from ARP to ground mark can also be
entered through the ANT command, which in this case
should be used as follows:
– Set f1 and f2 to “0.0”
– Enter the antenna height from ARP to ground mark as
f3 . Only when f1 = f2 =0.0 can you define f3 this way.
– f3 is negative when the ARP is below the SHMP.
Relevant Query
Command
$PASHQ,ANT
See Also
$PASHS,ANH
$PASHS,ANR
ATL: Debug Data Recording
Function
This command allows you to enable or disable the recording
of debug data. The resulting log file (called “ATL file”) is
saved to the memory selected through the $PASHS,MEM
command. The file is named as follows:.
ATL_yymmdd_hhmmss.log
Parameter Description Range
f1
Slant height measurement, from ground
mark (GM) to antenna edge (SHMP).
0-6.553 m
f2
Antenna radius: horizontal distance from the
geometrical center to the antenna edge.
0-6.553 m
f3
Vertical offset:
• From ARP to SHMP, if radius and slant
height are not null.
• From Ground Mark to ARP, if radius and
slant height are null.
0 to ±6.553 m
*cc Optional checksum *00-*FF