Operator Manual – KLR Series Amplifiers
Page - 9
All Rights Reserved
r
0611
Speaker Connections
(
Note: KLR 5000 speaker outputs not shown – see page 5)
Stereo Speaker Wiring
In this mode, the amplifier’s channels operate fully independent of each other. Each signal
enters the unit and is amplified separately and wired using different connectors.
Stereo Speaker Wiring Using Single 4-Conductor Speaker Cable
In this mode, the amplifier’s channels still operate independent of each other. Each signal is
amplified separately, however both channels are wired using the Channel 1 connector.
Bridged (Mono) Mode
In this mode, a single input is connected to channel 1 and is connected to the two output
channels that have been “Bridged” together using the Channel 1 connector. Minimum
Bridged load impedance is 4
Ω
.
Important Safety
Instructions – 2
Introduction - 3
The KLR Series - 4
Physical Description - 5
Installation – 6
Requirements
Installation Density
Typical Applications
Connectors & Polarity
Speaker Connections
Troubleshooting - 10
Spec Table - 11
Warranty - 12
