Attach the 2 pawls to the loom side from the inside with 30mm (1¼”) bolts. NOTE the “clicker pin” fits into
the gap in the pawl. Take care to ensure the “clicker pin” does not damage your table. Rub a little candle
wax on the thread to make assembly easier. Leave 0.5mm (1/32”) gap under the head of the bolt. DON’T
over tighten. The pawl should move freely and “Click” as it snaps past the pin.
Attach the front and back rails to the left side with 38mm (1½" ) screws.
Rub candle was over both ends of the front and back roller, then insert the short end of the rollers into the
holes in the left side.
Insert the long ends of the rollers into the right side and attach to the front and back rails with 38mm
(1½") screws.
Note:
When assembling the 120cm (48") loom use the 45mm (1¾") screws supplied.
40cm (16")
60cm (24")
80cm (32")
120cm (48")
