Page 2
Rev E EN
Installation
The Liberty solo is supplied the following components:
o
Main Unit
o
Liberty Solo Mouse Camera
o
Handwriting stand
o
Power supply adapter
o
Mains cable
o
Carry case
When setting up, it is important to choose your workplace carefully to avoid an
uncomfortable or awkward position. You should not have to raise your arm to
use the mouse; your wrist should be on the resting on the surface. The monitor
should be below eye level to avoid strain.
•
Remove the Liberty Solo main unit from its case and place on the work
surface.
•
Depress both handle release buttons and rotate the handle to allow you to
look onto or slightly down on the display.
•
Plug the mouse camera into either socket at the right hand side of the
main unit.
!
The mouse camera must be plugged in
before
powering on.
If it is
plugged in when the power is on, it may not operate properly.
•
An additional external camera or other video source (not supplied) can be
plugged into the second camera connector on the right hand side of the
unit. A suitable adapter is available from your distributor.
•
As it is supplied with the battery partially charged, we recommend that
you initially operate the Liberty Solo from the power supply. Plug the
power supply into a wall socket and insert the connector into the right
hand side of the unit above the mouse cable.
•
Power up the Liberty Solo by pressing the red power button (the right-
most button on the front panel).
•
When you place the mouse camera on some text you should see the
magnified image on the screen.
