It is always recommended to anchor the unit to the ground. Drill through
the four holes in the base of the unit using 6mm dia masonry drill to a
depth of 70mm. Screw in the anchor fixings. (These have a self cutting
thread). If not anchoring the unit, fit the self seal plugs BEFORE
BUILDING to seal the fixing holes from underneath.
TOOLS REQUIRED
Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill, a 10mm
socket or spanner.
FLEXISTORE 1511
BASE INSTRUCTIONS
Flat and firm base. Recommended: concrete, tarmac or paving flags.
Min. distance from walls/ shrubbery: 1000mm.
Min. base size (WxDxH) 1730mm x 1557mm x 50mm.
LEVELING THE UNIT
Correctly level the constructed unit using the shims (ZCOMPPLAS)
provided prior to fixing the unit to the ground. Slide the packing pieces
under the corners of the unit base as required until an equal gap has
been achieved around the door allowing for its smooth operation and
alignment.
For maintenance instructions of this product visit www.asgardsss.co.uk
Warning: some panels may weigh over
20Kg. Beware of manual handling
6mm
Dia.
10mm
Spanner
18V
x2
SEALANT
Posi-Driv
Screwdriver
ZSCREW32
x4
ZSILCOL1
x1
ZSCREW61
x138
ZSCREW340
x9
ZCOMPPLZS02
x4
ZCOMPPLAS22-23-24
x6
2x 2mm, 2x 3mm, 2x 5mm
SIDE P
ANEL
44295
x1
SIDE P
ANEL
44295
x1
RH FRONT
P
ANEL
44376
x1
DOOR 44374
x1
LH FRONT
P
ANEL
44164
x1
BASE P
ANEL
44298
x1
FASCIA
PANEL
44167
x1
TOP
PANEL
44294
x1
RH BACK P
ANEL
44159
x1
LH BACK P
ANEL
44158
x1
Warning: Please keep
this key card safe! Refer
to if replacement key is
required.
00001
YOUR UNIQUE
KEY CODE