Asgard Bike Locker, Assembly Instructions

Page: 3 / 4

L
M
S
T
U
PARTS
INSTRUCTION
POSITION FRAME 1 APROXIMATLEY IN ITS
REQUIRED POSITION, OFFER UP SIDE PANEL 2
ENSURING HOLES ARE ALIGNED
SCREW THE PANELS TOGETHER.
10*
PARTS
INSTRUCTION PARTS
INSTRUCTION
10* 20*
PARTS
INSTRUCTION
INSTRUCTION
INSTRUCTION
INSTRUCTION
INSTRUCTION
PARTS PARTS
PARTS
PARTS
STEP 1
STEP 2 STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
10*
24* 2* 2*
DOOR AND FRAME
SIDE PANEL 1 & 2
OFFER UP BACK PANEL 3
ENSURING HOLES ARE ALIGNED
SCREW THE PANELS TOGETHER.
BACK PANEL 3
OFFER 2ND SIDE PANEL 2
ENSURING HOLES ARE ALIGNED
SCREW THE PANELS TOGETHER.
SIDE PANEL 2
FIXING CHANNEL 6
2 off
HOOK FIXING CHANNELS 6 OVER THE BOTTOM BEND
OF SIDE PANEL AS SHOWN IN DETAIL *A* FIX IN PLACE
WITH SCREWS
42170 TOP 4
42397 TOP
STIFFENER 5
POSITION TOP PANEL 4 INTO PLACE ( SHORT SIDE TO FRONT)
ONTO ASSEMBLED SIDES AND BACK
FROM INSIDE FIT STIFFENER 5 INTO CENTER OF TOP
AND FIX WITH SCREWS LEAVING OUT THE 2ND AND 3RD SCREWS
FROM THE FRONT
LEAVE OUT 2ND AND 3RD
SCREWS UNTIL LATER
FIXED WITH CENTER SCREWS
WHEEL GUIDE 7
UNI HOOK 10
2off
CLIP WHEEL GUIDE 4 INTO POSITION
DOOR END FIRST( INTO RAIL) THEN INTO
SLOTS ON BACK PANEL
SCREW HOOKS 10 INTO REQUIRED POSITIONS
LH & RH 8 & 9
WHEEL GUIDES
SLOT LH & RH WHEEL 8&9
GUIDES INTO CENTER GUIDE
BOLT INTO POSITION
BOLT ON OUTSIDE NUTS ON IN SIDE
FIT 8 PLUGS INTO HOLES ON OUT SIDE OF END PANELS
(HOLES CAN BE USED TO FIX 2 UNITS SIDE BY SIDE)
LEVEL UNIT USING PACKERS SUPPLIED
FIX DOWN USING SELF CUTTING ANCHOR BOLTS
3 DOWN EACH SIDE 2 INTO GUIDE CHANNEL
FOR THIS YOU WILL NEED TO USE A 6mm
MASONRY DRILL DRILLING 70mm DEEP
THOUGH HOLES IN THE RAILS
SEALENT IS REQUIRED
HERE AT THE BACK OF
THE DOOR FRAME.
*A*
PRIOR TO FITTING ROOF PANEL APPLY
A CONTINUOS BEAD OF SEALENT ALONG THE
SIDES, BACK AND OVER THE DOOR FRAME
ALONG THE ROOF JOINT.
REMOVE ANY EXCESS SEALENT ALONG THE JOINT ENSURING
THAT THE SEAL IS COMPLETE.
DRG No 042487