Instruction of Parts
BTL-20 and BTL-30 Starting Mode/RPM Adjustment
Operating Instructions
1. When working with torque larger than 2 N.m (17.7 lbf.in),
please adjust RPM to less than 650 for safety purposes.
2. Make sure the power is switched off to install or replace
the screwdriver bit. Pressing the front-end iron cap will
allow the screwdriver bit to be inserted or released.
3. It is recommended to suspend the electric screwdriver from
a balancer for easy operation.
4. Adjust the torque dial to the proper position according to
the dial/torque table for each model.
5. Press the
Forward
switch to fasten the screw. The automatic
control model will shut off the power and stop the rotation of
the screwdriver bit as soon as the set torque value is reached.
6. Press the
Reverse
switch to loosen the screw.
7. Hold and keep the screwdriver and screw in a
perpendicular position with the work surface and apply
pressure slightly to prevent slipping.
8. Operate the electrical power screwdriver safely.
9. Do not press the
Forward/Reverse
switch at the same time
to prevent the short-circuit of the switch.
10. Use it under the normal operation frequency (8 working
hours per day and fastening 800-1000 screws per hour)
without exceeding the operation load will extend the life
time of the electric screwdriver and reduce the occurrences
of malfunction.
11. Please do not fasten wood screws.
Regular Maintenances
Check whether all the parts, housing, and power lines are in-tact
at all times to ensure normal operations. Unplug the power plug
and turn off the power before doing any maintenance operation
to ensure safety. Provide preventative maintenance for every
1000 hours of operation. Contact the ASG Service Department.
CAUTION:
• This electric screwdriver is designed for indoor use only.
Please do not use it in outdoors or wet environment to
prevent the danger of electrocution.
• Pay attention to the voltage specification. Make sure the
switch is in the OFF position when you plug in the power.
• Do not disassemble the device.
Output Torque/Adjust Dial
1. User can adjust output torque by changing the torque spring.
Please refer to the torque/dial table and then turn the torque
adjusting nut to set the proper dial for each model and set to
the desired torque for operations.
ASG BTL-20 and BTL-30 Torque Adjusting
• Please refer to the Output Torque/Adjust Dial table above to
adjust the working torque output.
• The torque scale is relative but not absolute.
• To ensure the absolute correct torque output, please
periodically use a torque tester to check and confirm the
torque output of the screwdrivers. ASG recommends the
ASG DTT Series digital torque testers.
Starting Mode Adjusting:
The starting mode adjusting
switch is in the middle of the
metal name plate
Turn to LEVER for Lever Start
Turn to PUSH for Push-to-Start
RPM Adjusting: The RPM Adjusting Knob
is at the bottom of the metal name plate
Adjust the RPM by small flat blade
screwdriver
Rotate clockwise for higher RPM
Rotate counter-clockwise for lower RPM