Asentria SiteBoss 530, User Manual

Page: 21 / 140

Asentria SiteBoss 530 User Manual
15
PPP Settings
displays the PPP Settings menu, where you can configure settings for PPP Dialout, PPP Hosting,
and IP Routing.
Email Settings
displays the Email settings menu, where you can configure the SMTP server address, Email
domain name, and authentication parameters.
Real-Time Socket Settings
displays the Real-Time Socket Settings menus where you can configure real-time
socket settings for each file of buffered data. Real-Time Sockets are used to collect data on TCP port 2201 from
a serial port in real-time, while buffering data if the network connection goes down.
SNMP Trap Capture Settings
displays the SNMP Trap Capture Settings menu where you can toggle this feature
ON or OFF, and select which file to store the traps in.
IP Address Restrictions
displays the IP Address Restrictions menu, where you can limit Ethernet and PPP
communications to or from specific IP addresses.
Static Route Settings
displays the Static Route Settings menu where you can configure static network routes.
DSL Settings
displays the DSL Settings menu where settings are configured so the S530 can communicate
using the optional ADSL Modem .
VPN Settings
displays the VPN Settings menu where settings are configured so the S530 can communicate with
the optional Asentria SitePath secure, unified administration portal software.
CPE Settings
displays the Customer Premises Equipment (CPE) Settings menu where up to 64 different
networked devices can be configured to communicate with the optional Asentria SitePath secure, unified,
administration portal software.
Ethernet Settings
Ethernet Settings displays the following menu where each of the two installed Ethernet ports can be configured:
Security Note:
If the S530 is going to be exposed to the Internet, make sure to use the other security
features available within the unit to prevent unauthorized access to your network. The other security features are
Strong Passwords, Challenge and Responses. Also, disallow insecure connections such as Telnet and FTP.
SiteBoss 530 - Ethernet Settings
A) Ethernet 1
B) Ethernet 2
Enter your Selection: a
SiteBoss 530 - Ethernet 1 Settings
A) Mode [STATIC]
B) IP Address [0.0.0.0]
C) Subnet Mask [255.255.255.0]
D) Router Address [0.0.0.0]
E) NAT [ON]
Mode
toggles between STATIC or DHCP – whichever is appropriate for this Ethernet port. Default setting is
STATIC.
IP Address
is the network address assigned to this Ethernet card. Default setting is 0.0.0.0
Subnet Mask
sets the network subnet mask provided by the network administrator. Default setting is
255.255.255.0
Router Address
sets the router address provided by the network administrator. Default setting is 0.0.0.0
NAT
is an ON/OFF toggle to enable Network Address Translation. Default setting is ON.