Asentria SiteBoss 530 User Manual
27
SSL Port
sets what port (TCP or UDP, as determined by the SSL Protocl) number the VPN uses. Default setting is
1194.
SSL Username / Password
sets the username and password that a VPN in SSL CLIENT mode uses when it
connects to an OpenVPN server. If the username is blank then the username "u<serial number>" will be used. E.g.,
"u5300009999" is the username the unit sends to the OpenVPN server if this setting is blank and the SSL Password
setting is not blank. The Username and Password make it so there is an extra layer of authentication to fulfill in order
for the VPN to connect. Note: the OpenVPN server must be configured appropriately for this.
SSL Manual Configuration
displays a menu to set up to 16 manual configuration items for OpenVPN, when the VPN
mode is either SSL Client or SSL Server. Any configuration items you need which are not automatically handled for
you by the unit (such as SSL port, SSL password, certificates, etc.) should be configured here.
Commissioning Settings
SiteBoss 530 - Commissioning Settings
A) IPsec Remote Private IP Address [0.0.0.0]
B) IPsec Commissioning Network [0.0.0.0/0]
C) Group Settings
D) Contact Name []
E) Contact Number []
F) Commissioning State [Commission Unit Now]
G) Commissioning IP Address [0.0.0.0]
Commissioning is covered in detail in the SitePath User Manual. Contact
for more
information.
CPE Settings
SiteBoss 530 - CPE Pages
A) CPE Page 1 (CPEs 1-16)
B) CPE Page 2 (CPEs 17-32)
C) CPE Page 3 (CPEs 33-48)
D) CPE Page 4 (CPEs 49-64)
Enter your Selection:
SiteBoss 530 - CPE Settings
A) CPE 1 [0.0.0.0]
.. . .
P) CPE 16 [0.0.0.0]
Enter your Selection:
SiteBoss 530 - CPE 1 Settings
A) IP Address [0.0.0.0]
B) Name []
C) Description []
D) Alarm Keep-alive Period (seconds) [0]
E) Alarm Threshold [1]
F) Enable SitePath Access [ON]
Following describes the menu options for configuring Customer Premises Equipment (CPE) Settings. These
settings are only for use with the Asentria SitePath secure, unified administration portal software and set up is
beyond the scope of this manual. Contact Asentria Technical Support for further information.
IP Address
sets the IP address of the CPE. Value is a dotted quad IP address. Default setting is 0.0.0.0
Summary of Contents for SiteBoss 530
Page 6: ......
