Aseko welldana ASIN Salt, User Manual, Page: 14 / 20

EN 14
RECOMMENDED
WATER PARAMETERS
Salt concentration
1,5 - 4 kg/m
3
1,5 - 4 ppm
pH
7,2 - 7,6
Alkalinity
80 - 150 ppm
Calcium hardness
Max 250 ppm
max. 14 dH
System start-up
Salting the pool water
Chlorine generating depends on the salt concentration and water temperature.
As lower the temperature as lower the chlorine production. You can boost the
electrolyzer by increasing the salt concentration. 1 kg of salt per cubic meter
of water can increase the electrolyzis power for about 20%. Maximum salt
quantity is 4kg/m³.
Exceeding of the recomended salt concentration will overload power supply
components of the ASIN AQUA Salt. The main unit is protected by maximum
current control circuit. At overload is the power supply automatically discon-
nected. Thin the salt concentration before switching the power supply again.
Never use lower salt concentration than 3g/l - this expressively reduce the
electrode lifetime. Higher salt concentration is very corrosive and may cause
corrosion of pool equipment.
Disinfection is expressively affected by following:
• temperature
• intensity of sun shining
• quantity of person using the pool
• weather conditions
• organic pollution
Instructions to operate the electrolyzer:
Never switch on the ASIN AQUA Salt before the salt concentration in the pool
water reach at least 3g/l. This may cause the electrode damage. Optimum
concentration is 4g/l.
Quantity of produced disinfection by ASIN AQUA Salt is controlled by salt
concentration, time of ASIN AQUA Salt operation.
Never switch on the ASIN AQUA Salt before dissolving of all salt.
Electrode connection to ASIN AQUA Salt must be done only when disconneted
power supply.
MAX POOL
VOLUME
Uncovered
60 m
3
Covered
90 m
3
Max. Salt
4 kg/m
3
Min. Salt
1,5 kg/m
3