Ascon Tecnologic - T31- OPERATING INSTRUCTIONS - PAG. 7
6. PROGRAMMABLE PARAMETERS TABLE
Here below is a description of all the parameters available on the instrument. Some of them may not be present, either due
to the fact they depend on the type of instrument or because they are automatically disabled as unnecessary.
Parameter
Description
Range
Default Note
1
S.Lt1 s.t1
min. Set time
0 ÷ S.Ht1
0
2
S.Ht1 s.t1
max. Set time
S.Lt1 ÷ 9999
10.00
3
S.St1 s.t1
Time range
1 Hours (9999 h);
2 Hours - Minutes (99 h 59 min);
3 Minutes - Seconds (99 min 59 s);
4 Seconds - Hundreds of seconf (99 s 99 1/100 s).
4
4
S.St2 s.t2
Time range
4
5
S.t2
s.t2
Set time
S.Lt2 ÷ S.Ht2
0.00
6
S.t3
s.t3
Set time
S.Lt1 ÷ S.Ht1
0.00
7
i.Fct
CNT input
operating mode
1 Bistable START/STOP;
2 Bistable RESET-START/STOP;
3 Monostable START/STOP;
4 Monostable RESET-START/STOP;
5 Bistable RESET/START/STOP;
6 Bistable START/STOP-RESET.
4
8
F.o1t
OUT1 output
operating
mode
1 On delay;
2 Feed-through;
3 Asymmetrical oscillator with start ON;
4 Asymmetrical oscillator with start OFF;
5 Asymmetrical oscillator with start OFF (one cycle only);
6 Delay in lack of excitation (or delay in de-excitation).
1
9
F.o2t
OUT2 output
operating
mode
oF No function;
1 Out2 operates as Out1;
2 Instantaneous Contact Output (ON during count);
3 Out2 operates as Out1, but with absolute Set time
s.t3
;
4 Out2 operates as Out1, but with relative Set time
s.t3
in advance;
5 Activation at the end of the count for the time
s.t2
(buzzer like);
6 Activation at
S.t1
count end with
S.t3
delay for
S.t2
time;
7 Activation at
S.t1
count end with
S.t2
delay;
8 Counting operation negated with respect to Out1;
9 Counting operation negated with respect to Out1 but with an
S.t3
dead time;
10 Symmetrical denied operation with respect to Out1 with
S.t3
dead time.
oF
10
t.PP
Password parameters
protection
oF Password disabled;
1 ÷ 9999
oF
