TD 93066EN
User Manual
Ascom Myco Smartphone
18. Maintenance
87
14 May 2018 / Ver. K
18.
Maintenance
This chapter includes the following sections:
•
•
•
18.3 Replace the Color Pad for the Hinge-Type Clip
18.1 Cleaning the Handset
Chemical Resistance
The exterior of the handset has been tested and found resistant to chipping, fading, or wearing
off, when the handset is treated with common cleaners, disinfectants, or perspiration. The
following chemicals are safe to use for cleaning the handset:
• 3 % Hydrochloric Acid
• M-alcohol (85 % Methylated Ethanol)
• 60 % Chlorhexidine 0.5 mg/ml
18.2 Battery Maintenance
Battery Life
Refer to the
Battery Storage and Maintenance Guidelines, For Ascom LiIon/LiPol battery packs
document.
18.3 Replace the Color Pad for the Hinge-Type Clip
Pads with different colors can be attached to the hinge-type clip for easy identification of the
handset. The different colors can, for instance, represent a workgroup or a shift.
18.3.1
Remove the Color Pad
1 On the back of the hinge-type clip, the colored pad is fastened with tabs in two places. Use
a paper clip, or a thin 3-4 mm flat screwdriver, to push against one of the tabs.
2 Once the colored pad bulges slightly outward (when applying slight pressure to one of the
tabs on the back of the colored pad) use a finger to pull downward from the center of the
colored pad until the pad comes off.
18.3.2 Attach the Color Pad
1 Align the colored pad with the cut-out for the pad on the hinge-type clip.
2 Attach the pad by pushing down on one end of the pad first. Then do the same thing on the
other end of the pad. Make sure that the color pad is flush to the clip.
CAUTION:
Avoid using acetone to clean the handset, as it damages the handset's
plastic casing.
