ASCOM LACERTA MOTORFOCUS, User Manual

Page: 15 / 21

LACERTA MOTORFOCUS 15 2016
Shortcuts
Esc (Press 1sec) Change the shaved and single Stepsnumber (display * or 1)
Ent (Press 1sec) Switch TempTrack function (display T or _ )
Direction buttons (
In
/
Out
)
The position counter starts from 0 normally, but this value is modifyable in the Menu.
Normally, one time pressing the in/out buttons means the motor takes 1 step. If you
would like to switch to the user defined
StepsPerClick mode, just press the Esc
button for 1 second. Then, on the display the first character at the upper row will
change to ’
*
’ with acoustic signal, and pressing in/out now takes the StepsPerClick
value which can be set in the menu (the default value is 50). If you would like to
return to 1 push / 1 step mode, just push again the
Esc button for 1 second. The ’
*
’
character will become ’ 1 ’.) If you push down the direction button permanently, the
motor will accelerate continuously until it reaches terminal velocity. After releasing the
button the motor slows down continously until it stopps.
The position cannot take values below 0, and also not more than the
PositionMax
value, which is setable in the Menu (default value is 15000). If the motor reaches the
position limits, an error message will be shown on the display with sounding a signal.
Use the In and Out buttons for scrolling up and down the menus, and for changing
values. In some menus the value input is dynamic: With continuously pressing the
button, and the value steps are more than 10, the counting will be in tens. If the
value steps are more than 100, the counting will be in hundreds. If the value steps
are more than 1000, the counting will be in thousands. If the counting reaches the
limit, the opposite limit will be the next value. (Example: In case of
GoStartPos menu
the next value after 65535 is the 0 and inversely.)
Function buttons (Ent, Esc, Goto) and menus
Ent button
Generally use for entering to menus and confirming.
Switch on/off Temperature compensation (
TempTrack ) by pressing down for 1
sec. If TempTrack is active, „ T ” character will be shown in the upper row on
the display.
Enter the Main menu by pressing
Ent together with Esc button.
Esc
button
Generally used to exit from menus, or cancelling changes.
Switch between 1 step/button pressing and
StepsPerClick stepping mode by
pressing down Esc for 1 sec. „ 1 ” or „
*
” is shown at the upper row on the
display.
Enter the Main menu by pressing
Esc together with Ent button.
Goto button
To reach the Goto quick menu, press this button for 1 sec.